User's Manual

Doc No: 890-03084 Date: 2017-02-13 Rev 02pa1
Yanzi Networks Installation Manual – Smart Office 15 of 19
9. Working with Sensors
9.1 LED Behavior
All sensors have a dual color LED that can indicate green or orange. The typical LED behaviors are
shown in the table below.
Sensor LED State Description Note
Off Power is off or sensor is in sleep All sensor turn the LED off a short
while after power has been applied to
avoid light pollution. A short press on
the button turns the LED on to display
status if sensor has power.
Short orange or
green blink
Power has just been applied and
sensor is booting up
Wait a few seconds for actual status
Blinking green (slow) Sensor is ready to be peered with a
location
Use the installation tool to peer the
sensor with a Gateway (Location)
Steady green Sensor is peered with a location and
working
Blinking green (fast) Sensor is about to be reset See details on resetting a device in
section below
Blinking
orange/green (fast)
Sensor has been reset to factory
default
See details on resetting a device in
section below
9.2 Resetting a device
If a device should be removed from an installation, please hold the button on the sensor pressed for about
20 seconds. After 15 seconds the LED will start flashing green quickly to warn that if you keep the button
pressed, it will reset. After another 5 seconds it will start flashing orange/green which means it is now
reset. Release the button and the sensor will reboot as factory default.