Operating Guide

10
This pressure washer is not intended to pump hot water. Never connect
it to a hot water supply as it will signicantly reduce the life of the pump.
7. OFF position (Fig. 8)
Make sure the ON/OFF switch is on the OFF position before plugging in the unit, press
the switch button with mark “O” to ensure it is o.
8. Take out power cord (Fig. 9)
Open the side storehousing and take out power cord with GFCI.
9.Connect to power socket (Fig. 10)
Insert the plug into the power socket.
WARNING
The pressure washer is also equipped with a main power “ON/OFF” (I/O)
switch located on the unit. It should always be moved to the “OFF” (O)
position when the pressure washer is not being used to prevent possible
injury or damage.
Ground Fault Circuit Interrupter Protection
This device provides additional protection from the risk of electrical shock.
Plug the Ground Fault Circuit Interrupter (GFCI) into a power outlet. Indicator
should turn red. TEST BEFORE EACH USE. Press the “TEST” button. Red
indicator should disappear. Press “RESET” button again for use. Do not use if
above test fails.
Fig.10
Green
25°
Used for
general clean
Turbo
Rotating flush
Black
Low pressure
Used for
detergent
Fig. 8 Fig. 9
Green
25°
Used for
general clean
Turbo
Rotating flush
Black
Low pressure
Used for
detergent