Operating Guide

8
Green
25°
Used for
general clean
Turbo
Rotating flush
Black
Low pressure
Used for
detergent
Fig. 2 Fig. 3
ASSEMBLY AND OPERATION INSTRUCTIONS
Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects that
could create a hazard. Remove any objects from the work area that could be tripped
over, such as toys or outdoor furniture. Ensure that all doors and windows are closed
tightly.
Water Supply (Cold Water Only)
Only draw water through the unit. For use with cold water supply only. Garden hose
must be at least a 1/2” (13 mm) in diameter. Flow rate of water supply must not fall
below 2 GPM (gallons per minute). Flow rate can be determined by running the water
for one minute into an empty 5-gallon container. The water supply temperature must
not exceed 104 °F (40 °C).
CAUTION
• Never use the pressure washer to draw in water contaminated with
solvents (e.g. paint thinners, gasoline, oil, etc.).
• Dirt in the water inlet will damage the unit. To avoid this risk, we
recommend checking the water lter (located inside the water inlet. To
clean it out, see Maintenance section).
• Always prevent debris from being drawn into the unit by using a clean
water source and an additional accessory water lter if required.
• To prolong the life of the unit, rest the unit for 5 minutes after every 30
minutes of use.
MACHINE ASSEMBLY
Your YardForce pressure washer will need following tools free assemble before
operation:
1. Take out high-pressure hose (Fig. 2)
Open the back storehousing and take out the hige-pressure hose for assembly.
2. Connect high-pressure hose to pressure washer (Fig. 3)
Attach the high-pressure hose to the pressure washer’s outlet, tigthen by hand.