Instruction manual

Engine Model: RM55, RM55ES
RM65, RM65ES
RM45 (OHV)
Page
29 of 40 Mountfield 160+200cc & 140cc OHV Selfhelp Guide 2011, Issue 1.0
FOR MULTICLIP
MOWERS:
If the above steps do not return the tension to
the cable and restore the drive, the cause of
the problem may be the belt has come off the
drive pulleys (see Section B) or the clutch cable
has broken or become detached (see a service
dealer).
a) Check the clutch cable runs up
the RIGHT hand side of the
main handle through the
anchoring bracket on the
handle. If the cable is not in
this bracket, insert it and
secure it there with the
securing bolt, then follow the
instructions in b) below to
adjust the tension.
b) The cable may have stretched
a little with use. Slacken the
bottom nut on the adjusting
barrel and then tighten the top
nut on the adjusting barrel to
take up un-required slack in the
cable. NOTE: The cable
should have about ½” of play
on it.
Find your local ServiceLink
centre at
www.servicelink.org.uk