Operator`s manual

10 Deluxe 2-Cycle & 4-Cycle Tiller Operator’s Manual

Assembly

• You’ll need the 2 Tines and the

2 Retaining pins

• Remove the unit from the

cardboard cradle and turn the

unit slightly on its side

• You will notice that one side of the

Tine has a circular hole while the

other has a “D” shaped hole.

TINE ASSEMBLY

123

• Attach the Tine so that the circular hole

slides onto the axle ﬁ rst.

• When the axle protrudes from the

other side it will line up perfectly

with the “D” shaped hole.

• Slide a Retaining Pin through the

hole in the axle to secure the Tine.

• Repeat steps for the other side.

456

• To assemble the Upper Handles,

ﬁ rst put the Kickstand down

• Layout the Middle and Upper Handles

and the Handle Brace as shown above

• Take the Right Middle Handle and

attach the brace using a hex head

cap screw and a 2-way lock nut.

Finger tighten.

• Repeat for left side.

UPPER HANDLE ASSEMBLY

*NOTE: The Tiller is laying down for assembly purposes only.

See page 14 for important information.