Use and Care Manual

Set-Up
Shear Pins Storage (if so equipped)
A pair of replacement auger shear pins and bow tie cotter pins
are included with your snow thrower. If your snow thrower has
a 2-Way or 4-Way crank style, you may store them in your snow
thrower’s dash panel until needed. If your snow thrower has
an overhead or side chute control, store the shear pins in a safe
place until needed. See Fig. 3-26.
Chute Clean-Out Tool
The chute clean-out tool is fastened to the top of the auger
housing with a mounting clip and a cable tie at the factory. Cut
the cable tie before operating the snow thrower. See Fig. 3-27.
Chute Clean-Out
Tool
Figure 3-26
Figure 3-27
Drift Cutters (if so equipped)
Remove the two screws and lock nuts that secure each 1.
drift cutter, and remove them from the sides of the auger
housing.
Turn the drift cutters around and position them as shown 2.
in Fig. 3-28 to the outside of the auger housing.
Attach the drift cutters with the screws and lock nuts 3.
removed earlier.
Tire Pressure
WARNING! Under any circumstance do not exceed
manufacturer’s recommended psi. Equal tire
pressure should be maintained at all times. Excessive
pressure when seating beads may cause tire/rim
assembly to burst with force sufficient to cause
serious injury. Refer to sidewall of tire for
recommended pressure.
The tires are over-inflated for shipping purposes. Check the tire
pressure before operating the snow thrower. Refer to the tire side
wall for tire manufacturer’s recommended psi and deflate (or
inflate) the tires as necessary.
NOTE: Equal tire pressure is to be maintained at all times for
performance purposes.
Figure 3-28
15se c t i O n 3 — as s e M b l y & se t -up