Use and Care Manual

Place chute onto chute base and ensure chute control 3.
rod is positioned under the handle panel. Install hex bolt
previously removed but do not secure with wing nut at this
time. See Fig. 3-5.
Squeeze the trigger on the joystick and rotate the chute by 4.
hand to face forward. The holes in the chute control input
will be facing up. See Fig. 3-6.
NOTE: The chute will not rotate without squeezing the
trigger on the joystick.
Chute Assembly
Remove hairpin clip, wing nut and hex screw from chute 1.
control head and clevis pin and bow-tie cotter pin from
chute support bracket. See Fig. 3-3.
Insert chute control rod into chute control head. Push rod 2.
as far into chute control head as possible, keeping the
holes in the rod pointing upward. See Fig. 3-4.
Figure 3-4
Chute Control Head
Chute
Chute Support
Bracket
Chute Base
Figure 3-3
Figure 3-5
Top View
Chute Control
Input
Figure 3-6
9se c t i O n 3 — as s e M b l y & se t -up