Use and Care Manual

Assembly & Set-Up

Contents of Carton

• One Snow Thrower • One 20 oz. Bottle 5W-30 Oil • Two Ignition Keys

• One Chute Assembly • One Electric Starter Cord (If equipped) • One Snow Thrower Operator’s Manual

• One Engine Operator’s Manual

NOTE: This Operator’s Manual covers several models. Snow

thrower features may vary by model. Not all features in this

manual are applicable to all snow thrower models and the snow

thrower depicted may differ from yours.

NOTE: All references to the left or right side of the snow thrower

are from the operator’s position. Any exceptions will be noted.

Assembly

Positioning the Upper Handle

1. Remove the wing knob and carriage bolt from the top

of the lower handle. See Figure 3-1. It is not necessary to

remove the shoulder screw and flange lock nut below the

wing knob and carriage bolt.

Wing Knob

Carriage Bolts

Figure 3-1

2. Pivot the upper handle into the operating position. Be sure

not to pinch any of the cables in the process. See Figure 3-2.

Figure 3-2

Installing the Chute

1. Remove the hex washer screws in the chute base. See

Figure 3-3.

Figure 3-3