Use and Care Manual

Assembly
Handle
Place the shift lever in the forward-6 position.1.
Observe the lower rear area of the snow thrower to be sure 2.
both cables are aligned with roller guides before pivoting
the handle upward. See Fig. 3-1.
NOTE: Make certain the upper ends of each cable are
seated properly in its pulley. See Fig. 3-2.
Secure the handle by tightening the plastic knob located 2.
on both the left and right sides of the handle. Remove
and discard any rubber bands, if present. They are for
packaging purposes only.
Chute Assembly
Position the chute assembly over the base. See Fig. 3-3.1.
Contents of Carton
One Snow Thrower• Two Replacement Auger Shear Pins• One Chute Assembly•
One Snow Thrower Operator’s •
Manual
One Product Registration Card• One Chute Rod•
Figure 3-1
Figure 3-2
Figure 3-3
Assembly & Set-Up
3
7