Instructions / Assembly

Finish fastening using the 1 3/4" washer head screws

provided.

Rotate the swing beam 180 degrees so that the swing

bearings are turned up. Fasten the swing beam receiver

bracket to the swing beam using two 4 7/8" bolts

provided. This bracket needs to be fastened to the end of

the swing beam without the caps. Thread acorn nut onto

bolt as far as you can, then back off several turns. Use

washers between the acorn nut and the metal bracket.

Tighten nuts.

Step 6:

Step 5:

Swing Frame Assembly

With swing beam in same position, attach beam strap to

swing beam using two 4 7/8" bolts provided. Only

finger tighten at this point. Note that this end of the

beam should have caps on it. Use pre-drilled holes.

Step 7:

Step 8:

Identify end post and place between beam strap. Fasten

using two 4 7/8" bolts provided. You are now ready to

tighten all four bolts on beam strap.

If your setup location is level, the end post will need to

be shortened approximately 1' (cut off bottom end).