Instructions / Assembly

Swing beam receiver properly fastened.

Identify ground runner and fasten to end post using

6 1/2" bolts. Thread acorn nut onto rod as far as you can,

then back off several turns. Be sure to place washer

between acorn nut and vinyl.

Step 13:

Step 16:

Step 15:

Step 14:

Identify end post braces. Fasten the short angle to the

ground runner that was installed on previous step.

Use 4 /18" bolts provided.

Align brace with end post then fasten long angle to end

post using 3/8" x 4" lags provided. This should be pre-

drilled using 1/4" drill bit.

Swing Frame Assembly