Installation & Assembly

13
(80) Before fastening the full piec-
es, check to see if the door opening
is square. IF NOT, pull the bot-
tom of the wall left or right to
adjust it, then fasten the rest of
the pieces.
(82) Fasten the front wall secure-
ly, repeating steps (59 to 67)
(81) Cut the end of the siding, re-
peating steps (51 and 52)
Then, install soffit, repeating steps
(53 to 58)
(86) Fasten to floor, using 3”
screws, every 12 to 14 inches, try-
ing to hit the floor joist.
(87) Align gable wall framing flush
with back wall framing and attach
using 3” screws, every 12 to 14
inches.
(88) Repeat the process on front
side.
(83) Locate and lay out the parts to
assemble the gable wall with no
garage door opening. Note: Gable
walls are inter-changeable. Place
garage door opening on desired
gable wall. Top and bottom wall
plates for the garage door have
double dados for the door studs.
(84) Attach all wall studs to top
and bottom and wall plates.
(85) Set the gable wall.
Note: You might need to remove
a brace on one wall before set-
ting the gable wall.
[phone] - [e-mail]
Assemble Solid Gable Wall