Installation & Assembly

18
(125) Toe screw all the rafters to
top wall plate, making sure rafter
is straight.
(127) Snap a chalk line 1/4” below
the bottom of the soffit as shown.
Note: The peak pieces in the front
will be sticking down past the gar-
age door opening. Once installed,
cut it back flush with the frame,
using the same method as before.
(126) Lay out the gable peak piec-
es as shown, with the over lap to-
wards the front.
(131) Starting with the left gable
overhang, put the overhang in
place, then refer to the next step
before fastening.
(132) Make sure the gable over-
hang is flush with the rafter, and
tight in against the gable siding, as
shown.
(133) Fasten gable overhang to
rafter, using 2” screws, every 8 to
12 inches.
(128) Install the piece towards the
front first, making sure it is aligned
with the rafter and the chalk line.
Note: Grooves in gable siding
should align with grooves in wall
siding, as shown in next step.
(129) Correct! Fasten firmly with
2” siding nails.
(130) Repeat with the rest of the
peak pieces, making sure the bot-
tom is flush with the chalk line.
Repeat the process on the other
gable, again; making sure over-
lap is towards the front.
[phone] - [e-mail]
Install Gable Peak Siding
Install Gable Overhangs