Specification

14
(89) Locate and lay out the parts to
assemble the gable wall with ga-
rage door opening.
Note: Gable walls are inter-
changeable. Place garage door
opening on desired gable wall.
(91) Cut the bottom plate at garage
door opening, using a sawzaw. Re-
peat on opposite end.
(90) Attach all wall studs to top
and bottom wall plate.
Note: Top and bottom wall
plates have double dados for the
door studs.
(95) Set this gable wall.
Door opening needs to be 9’ wide.
Note: You might need to remove
a brace on one wall before setting
the gable wall.
(96) Fasten the bottom plate to the
floor.
(97) Align gable wall framing
flush with back wall framing and
attach using 3” screws, every 12 to
14 inches. Repeat on opposite side.
(92) Move the bottom plate cutout
piece up to the top of door open-
ing, and fasten securely, using 3”
screws.
(93) Make a mark at 11-1/4” as
shown.
(94) Fasten the garage door brace
on the top and bottom, using the
mark as a guide.
Repeat for the other door brace.
[phone] - [e-mail]
Assemble Gable Wall With Garage Door Opening