Specification

16
(107) Run a 2” screw through sid-
ing at each corner of the window.
(109) Remove the screws and
chalk line, then; set the saw at
1/2”, and cut along the lines.
(108) Use the screws to snap a
chalk line outlining window frame.
(113) Cut out bottom plate at the
double door opening, using a saw-
zaw.
(114) Fasten two 2x4s to each other
at the inside to inside width, to be
used as a wall spacer, then move to
next step.
(115) Move the 2x4 wall spacer to
just below the top plate, and fasten
it on both sides, making sure the
walls are pulled in against the 2x4.
This will ensure that walls are
properly spaced.
(110) Repeat for the other window,
and also the garage door, using the
same method.
(111) For the bottom of the garage
door, where the circular saw can
not access, use either the sawzaw
or a chisel to cut the bottom.
(112) Done!
[phone] - [e-mail]
Cut Out For Windows and Garage Doors