Installation Guide

 9 [e-mail]
Step 2: Attach Inserts
Part 2
HardwareWood Parts
B:Withanadulthelperstanduppostsandplaceone(211)SeatBackontheoutsideofboth(227)XPanelPost
Backandtighttothetopof(215)ShortWideSupports(g2.3&2.4).Noticetheholeistowardthebottomofthe
board.Insertone1/4”ConnectorNutinto(211)SeatBackandlooselyattachtopreviouslyinstalled(YB4)1/4x3
3/4”WaferBoltoneachside(g2.4).

C:Placeone(210)SeatFrontontheoutsideofboth(217)XPanelPostFrontandtighttothetopof(214)Short
Supports(g2.3&2.4).Noticetheholeandanglededgeistowardsthetopoftheboardandthebevelededge
facesout(g2.4).Insertone1/4”ConnectorNutinto(210)SeatFrontandlooselyattachtopreviouslyinstalled
(YB4)1/4x33/4”WaferBoltoneachside(g2.3).
1 x Seat Front 38.1 x 76.2 x 1524 mm
1 x Seat Back 38.1 x 76.2 x 1524 mm
Fig. 2.3
210
4 x 1/4” connector nut
Fig. 2.4
210
215
211
227
217
214
YB4
(previously
installed)
1/4”ConnectorNut
211
Notice bevelled
edge face out
Tight
227
227
217
217
Noticehole
location

Notice angled
edge towards top