Installation Guide

ManualsBrandsYardistry ManualsKitchenCorner Climber

Installation Manual -G006

Corner Climber

YM11554

Yardistry Ltd.

Mount Forest, ON Canada N0G 2L1

Toll Free Customer Support: 1.888.509.4382

info@yardistrystructures.com

www.yardistrystructures.com

Revised 08/24/2011

(0.51m)

(0.69m)

(0.51m)

(0.69m)

(1.61m)

63 ½”

Summary of content (7 pages)

PAGE 1
Installation Manual -G006 Corner Climber YM11554 63 ½” (1.61m) (0.51m) (0.69m) (0.51m) (0.69m) Yardistry Ltd. Mount Forest, ON Canada N0G 2L1 Toll Free Customer Support: 1.888.509.4382 info@yardistrystructures.com www.yardistrystructures.
PAGE 2
!Important Safety Notice! • Yardistry components are intended for privacy, decorative and ornamental use only. Product is NOT INTENDED for the following: - A safety barrier to prevent unsupervised access to pools, hot tubs, spas, or ponds. - Safety railings for elevated platforms or decks. - As load bearing support for a building, structure, heavy objects or swings. - Used in structures that trap wind, rain or snow that would create extra load on the product.
PAGE 3
Material List R Top and Bottom Rail -2x 7 1/4” (18.4cm) and 2x 20” (50.8cm) S4 S4 S4 S7 #8 x 2 1/4” Wood Screw S5 S4 S7 S5 #10 x 1” Pan Head Screw P 4x4 Posts - 1x 63” (1.60m) and 2x 49 1/4” (1.
PAGE 4
Insert male into female. Slide down until flush with also be connected together as à deux ou à trois carreaux de hauteur Panels if required. altos apanel. medida que se adquieran. adjacent purchased. séparément). os paneles.*Use 2 1/4" stainless steel screws *Use los tornillos de acero inoxidable (vendus *Utilisez vis en acier inoxydable de de 2 1/4"el queextremo se incluyen en el juego en el les Introduzca macho extremo hembra.
PAGE 5
Step 2- Attach Panel Clips For Wings 1. On a flat surface place P- 4x4 Post on its side and position Panel Clips in locations indicated in Figures 1 and 1A. Ensure Panel Clips are oriented as shown in Diagrams! Fig. 2 2. Panel Clips should be placed in the centre of the post or the leading edge of the clip should be 1 3/8” or 3.49cm away from the side of the post as shown in Fig. 2. 3. With Panel Clips in place, mark screw holes with a pencil and pre-drill holes with a 1/8” drill bit. (Not provided) 4.
PAGE 6
Step 3- Attaching Post Caps 1. Place a Post Cap on each 4x4 Post 2.
PAGE 7
This identifies information that requires special Check that set or assembly is properly level before proceeding. Step 4- A ttach to attention. Wings Improper assembly couldPosts lead to an unsafe or dangerous condition. Use Use Pre-drill 1/8” & 3/16” Bit Where this is shown, 2 or 3 Help Help Pre-drill a pilot hole 1. Place panel assemblies on posts as shownpeople (Fig.1) a safely 2” gap between areallowing required to before fastening screw the step.