Installation Guide

25 [e-mail]
It is important the proper hardware gets
placed in the places shown. Make sure
you install the Wafer Bolt rst and then
the wood screws.
A: Attach one (195) Arch Beam Front in
between two Corner Post Assemblies as
shown in g. 10.2 and attach to Corner
Post Assembly with one 1/4 x 4-1/4” Wafer
Bolt (with 5/16” at washer); and one 1/4
x 3-3/4” Wafer Bolt (with 5/16” at washer
and 1/4” connector nut) per side. (g. 10.1)
B: Attach three #8 x 3” wood screws
per side.
C: Repeat for the opposite side.
Step 10: Attach Arch Beam Fronts
2 x (195) Arch Beam Front 38.1 x 241.3 x 3048 mm (2 x 6 x 120”)
HardwareWood Parts
Fig. 10.2
12 x #8 x 3” Wood Screw
4 x 1/4 x 4-1/4” Wafer Bolt (5/16” at washer, 1/4” connector nut)
4 x 1/4 x 3-3/4” Wafer Bolt (5/16” at washer, 1/4” connector nut)
Fig. 10.1
1/4 x 4-1/4”
Wafer Bolt
#8 x 3”
Wood
Screw
Flat
Washer
Corner of
Corner Post
Assembly
(195) Arch
Beam Front
(195) Arch
Beam Front
Outside
Panel Post
#8 x 3”
Wood
Screw
1/4 x 3-3/4”
Wafer Bolt
(195) Arch
Beam Front
Connector
Nut
Flat
Washer