Installation Guide

31 [e-mail]
It is important the proper hardware gets placed in
the places shown.
B: Attach one (231) Support Beam to each Beam End
Assembly and (235) Engineered Panel Corner Post
Long by replacing the 5/16 x 6” Hex Bolt (lock washer
and at washer) removed in Part 1. (g 13.3 & 13.4)
Ensure the cut outs in the boards are interlocking as
shown in g. 13.5.
C: Using two 5/16 x 3” Hex Bolts (with lock washer,
at washer and t-nut) attach the interlocking cut outs
of (231) Support Beams to (234) Beam 105 1/2” as
shown in g. 13.5.
Step 13: Attach Support Beams
Part 2
Hardware
Fig. 13.4
Fig. 13.3
Fig. 13.5
Beam End
Assembly
(231) Support
Beam
5/16 x 6” Hex Bolt
(previously removed)
5/16 at washer
5/16 lock washer
(231) Support Beam
(235) Engineered
Panel Corner Post
Long
5/16 x 3” Hex Bolt
5/16 at washer
5/16 lock washer
5/16” t-nut
(234) Beam 105 1/2”
(231) Support
Beam
Notice board
orientation
4 x 5/16 x 3” Hex Bolt
(5/16 at washer, 5/16 lock washer, 5/16” T-nut)
4 x 5/16 x 6” Hex Bolt (previously removed)
(5/16 at washer, 5/16” lock washer & previously installed
5/16” T-nut)
Wood Parts
4 x (231) Support Beam 38.1 x 139.7 x 1866.9 mm