Installation Guide

35 [e-mail]
Hardware
Step 14: Attach Roof Panels - Large Roof
Part 1
A: Place one Middle Panel on the front of one Large Roof Rafter Assembly so it slightly overhangs the top of
(434) Top and an overhang at the bottom of the Large Fascia Beam Assembly. Holes should line up with (440)
Rafter and (430), (431) and (432) Straps (g. 14.1)
B: Place one Long Panel Left and one Long Panel Right on each side of Middle Panel so they overlap the
Middle Panel and are ush to the sides of (438) Rafter Corner Left and (439) Rafter Corner Right and an
overhang at the bottom of the Large Fascia Beam Assembly. Attach with two #8 x 1” Roong Screws per panel
in the places shown below. Be sure not to overtighten screws. (g. 14.2)
Fig. 14.2
Fig. 14.1
8 x #8 x 1” Roong Screw
Roof Parts
2 x Middle Panel
2 x Long Panel Left
2 x Long Panel Right
Large Fascia
Beam Assembly
(438) Rafter
Corner Left
(439) Rafter
Corner Right
Panels overlap
at the seams
(440)
Rafter
(431) Strap
Left - Large
Roof
(430) Strap
Short - Large
Roof
Long Panel
Left
Long Panel Right
DO NOT overtighten
screws, could cause
damage to roong
material
Flush
Flush
Large Fascia
Beam Assembly
(432) Strap
Right -
Large Roof
(440)
Rafter
(hidden)
(434) Top
(hidden)
Slight
overhang
Middle Panel
Middle Panel
Will overhang
Will overhang