Instructions / Assembly

20 [e-mail]
Note: The bevelled ends on each gusset should always face away from the wood it is attaching to.
A: Make sure the assembly is still square and level then facing one Long or Short Beam Assembly place one
(705) Gusset Right on the right hand side so the top ts tight to the Beam Assembly and the bottom ts tight to the
Post Assembly. Attach gusset to Beam Assembly with two 5/16 x 3-3/4” Hex Bolts (with 5/16” lock washer, 1/4-
5/16” large washer and 5/16” t-nut). Pre-drill with a 1/8” drill bit then attach gusset to Post Assembly with three 1/4
x 1-15/16” Hex Lags (with 1/4-5/16” large washer). (g. 6.1, 6.2 and 6.3)
B: Repeat Step A on the left hand side with one (706) Gusset Left. (g. 6.1, 6.2 and 6.3)
C: Repeat Steps A and B for each Beam Assembly/Post Assembly. (g. 6.1, 6.2 and 6.3)
D: At each corner, tight to the outside edges of the joining Beam Assemblies attach one Roof to Post Bracket with
two #10 x 1-1/4” Pan Screws. (g. 6.3 and 6.4)
Step 6: Attach Gussets and Roof Brackets
Fig. 6.1
Tight
Hardware
24 x 1/4 x 1-15/16” Hex Lag (1/4-5/16” large washer)
16 x 5/16 x 3-3/4” Hex Bolt
(5/16” lock washer, 1/4-5/16” large washer, 5/16” t-nut)
8 x #10 x 1-1/4” Pan Screw
4 x Roof to Post Bracket
Fig. 6.2
(705) Gusset
Right
Roof to Post
Bracket
#10 x 1-1/4”
Pan Screw
(706) Gusset
Left
Long Beam
Assembly
Post
Assembly
(705) Gusset
Right
(706) Gusset
Left
Long Beam
Assembly
Post
Assembly
Short Beam
Assembly
1/4 x
1-15/16”
Hex Lag
5/16”
T-nut
5/16” Lock
Washer
1/4-5/16”
Large Washer
5/16 x 3-3/4”
Hex Bolt
5/16 x 3-3/4”
Hex Bolt
Fig. 6.3
Fig. 6.4
(706)
Gusset
Left
(706) Gusset
Left
(706) Gusset
Left
(705)
Gusset
Right
(706) Gusset
Left
Short Beam
Assembly
Long Beam
Assembly
Short Beam
Assembly
1/4-5/16”
Large Washer
1/4-5/16”
Large Washer
1/4 x
1-15/16”
Hex Lag
(705) Gusset
Right
(705) Gusset
Right
(705)
Gusset
Right
4 x (705) Gusset Right
4 x (706) Gusset Left
Wood Parts