Instructions / Assembly

51 [e-mail]
Step 24: Attach Ridge Caps to Roof Panels
A: Slide one Ridge Cap Long 81.5 over the Ridge Clips, with cut end leading, on each corner of the assembly
from the bottom up. Slide Ridge Cap Short 25.2 over the Ridge Clips leading with the insert end to push the
Ridge Cap Long 81.5 to the top, lifting Peak Cap Long by pushing up the Peak Loop so Ridge Cap Long 81.5s t
under Peak Cap Long. Attach with two #8 x 3/4” Sheet Metal Screws per Ridge Cap set. (g. 24.1, 24.2, 24.3,
24.4 and 24.5)
B: Tighten Loop to secure Roof Peak Set.
Hardware
8 x #8 x 3/4” Sheet Metal Screw
Componets:
4 x Ridge Cap Long 81.5
4 x Ridge Cap Short 25.2
Ridge Cap
Short 25.2
Ridge Clip
102.5
#8 x 3/4” Sheet Metal Screw
Fig. 24.1
Fig. 24.3
Fig. 24.4
x 3
Cut End
Note: To help Ridge Caps
slide on easier use a
lubricant such as liquid soap.
Fig. 24.2
Ridge Cap
Long 81.5
Insert End
Fig. 24.5
Peak Cap
Long
Folded
End
Ridge Cap
Short 25.2
Ridge Cap
Long 81.5
Ridge Cap
Short 25.2
Ridge Cap
Long 81.5
Ridge Cap
Long 81.5