Installation Guide

 18 [e-mail]
Step 10: Attach Canopy to Catch
Hardware
1 x #12 x 1” Pan Screw
A:TightentheTurnbucklesoitissnug.IfitistooloosethecablewillspininthePulleyAssembly,ifitistoo
tightthepulleywillnotturn.(g.10.1)
B:Fullyopen12’x12’RetractableCanopy,placeCabletoRibConnectoroverrstRibAssemblyandsecure
withone#12x1”PanScrew.(g.10.2)
#12x1”
PanScrew
12’x12’
RetractableCanopy
andRibAssembly
Fig. 10.2
Fig. 10.1
Turnbuckle
Note: Remove the Canopy prior to snow or
heavy winds by removing the screws from
the Cable to Rib Connector and removing the
Canopy from the Fireman’s Hooks.
CabletoRib
Connector