Installation Guide

 9 [e-mail]
Step 3: Attach Roller Channel Assemblies to Pergola
Fig. 3.2
A:
FromtheinsideofeachBeamEndmeasure38-1/8”alongboth
ArchBeamFronts.(g.3.2)
B:WithahelperattachoneRollerChannelAssemblytoeach
ArchBeamFrontatthemarkedoutlocationswithtwo#12x1”Pan
Screws(with1/4”atwasher).(g.3.1,3.2and3.3)
C:AttachRollerChannelAssemblytoCentreBeamandeachArch
BeamOffsetwiththree#12x1”PanScrews(with1/4”atwasher).
(g.3.2,3.3and3.4)
D:RepeatStepsA-CforthesecondRollerChannelAssembly.
Note: Do not overtighten screws.
BeamEnd
Roller
Channel
Assembly
ArchBeam
Offset
#12x1”
PanScrew
w/1/4”Flat
Washer
Hardware
10 x #12 x 1” Pan Screw
(1/4” at washer)
38-1/8”
38-1/8”
Fig. 3.1
BeamEnd
BeamEnd
34-1/4”
BeamEnd
34-1/4”
BeamEnd
34-1/4”
BeamEnd
34-1/4”
ArchBeam
Offset
ArchBeam
Front
ArchBeam
Front
Centre
Beam
ArchBeam
Front
Roller
Channel
Assembly
Fig. 3.3
Fig. 3.4
Roller
Channel
Assembly
Roller
Channel
Assembly