Assembly Manual

16
PARTS REQUIRED:
FINISH
You have  nished rafter jig. Proceed to assemble your rafters.
RAFTER ASSEMBLY
96"
(243,8 cm)
35-3/16"
(89,4 cm)
35-3/16"
(89,4 cm)
48"
(122 cm)
3/4"
(1,9 cm)
CPA CPA
CPA
3" (7,6 cm)
x6
Measure over 48" and up 35-3/16" from the  oor edges and secure CPA using two 3" screws.
Check CPA is 35-3/16" at both ends for squareness.
BEGIN
¸
1
Secure one CPA  ush to the  oor deck using two 3" screws.
Measure over 96-3/4" and install a second CPA  ush to the  oor deck. CPA will overhang the  oor.
Secure using two 3" screws.
2
96-3/4"
(245,7 cm)
IMPORTANT MEASUREMENT !!
Fig. B
Fig. A
You will build a rafter jig using the  oor and three CPA parts as shown.
Floor Width
(2) 3" (7,6 cm)
Screws
in each CPA
There will be an
overhang on
this end.
Flush Flush
x3
2 x 4 x 8-1/2" (5,1 x 10,2 x 21,6 cm)
CPA