Assembly Manual

FRONT WALL WITH DOOR LEFT
26
You have  nished building your front wall.
FINISH
6
Carefully  ip the front wall over.
PARTS REQUIRED:
x127
2" (5,1 cm)
x2
3/8 x 11-7/8 x 84"
(1 x 30,2 x 213,4 cm)
3" (7,6 cm)
x2
3
Primed
side up
Primed
side up
For squareness maintain
 ush along panel edges.
Flush
Flush
FlushFlush
Go to page 33.
6"
(15,2 cm)
12"
(30,5 cm)
32"
(81,3 cm)
Flush Flush
3" (7,6 cm)
Screws
ATA
Temporary Support
Place 11-7/8" x 84" end panels primed side up onto wall frame,  ush to top of frame
and  ush to installed panels.
Secure panel with 2" nails 6" apart on edges and 12" apart inside panel.
4
5
Attach ATA temporary support using 3" screws into wall frame as shown.
Hold the 32" (81,3 cm) dimension.
x1
3/8 x 48 x 84"
(1 x 121,9 x 213,4 cm)
3/8 x 48 x 84"
(1 x 121,9 x 213,4 cm)
3/8 x 11-7/8 x 84"
(1 x 30,2 x 213,4 cm)
3/8 x 11-7/8 x 84"
(1 x 30,2 x 213,4 cm)
Place 2nd 48" x 84" window panel primed side up onto wall frame,  ush to top of frame and  ush to
installed panel. Use the gauge block to mark the 3/4" measurement on the wall stud.
Secure panel with 2" nails 6" apart on edges and 12" apart inside panel.
ATA Temporary Support
x1
2 x 4 x 64-1/8" (5,1 x 10,2 x 162,9 cm)