Assembly Manual

52
3" (7,6 cm)
PARTS REQUIRED:
RAFTERS
x28
Align over studs.
24"
(61 cm)
24"
(61 cm)
24"
(61 cm)
24"
(61 cm)
24"
(61 cm)
24-3/8"
(61,9) cm)
24-3/8"
(61,9) cm)
MEASUREMENTS ARE TO CENTER OF RAFTER
FLUSH WITH OUTSIDE OF WALL PANEL
x6
Pre-Assembled Rafter
with 2 gussets
x2
Pre-Assembled Rafter
with 1 gusset
FINISH
Place remaining 2 gusset rafters on top plate, aligned over studs as shown and secure with 3" screws
(Fig. B).
Locate and secure both 1 gusset rafters 3/8" over top plate with one 3" screw above notch (Fig. C).
NOTE: Gussets face inside of shed.
Secure rafter to top plate with two 3" screws above notch (Fig. B).
You have  nished installing your rafters.
3
BEGIN
¸
1
Locate  rst 2 gusset rafter on top plate, aligned over studs at each side and tight to side wall
(Fig. A, Fig. B).
2
Repeat Steps 1 - 3 to secure rafters to opposite side top plate.
4
BEGIN
HERE
Fig. A
Flush
Flush
1 Gusset
Rafter
1 Gusset
Rafter
Fig. B
Tight to
side wall
(3) 3" (7,6 cm)
Screws
Fig. C
3" (7,6 cm)
Screw
1 Gusset
Rafter
Top Plate
3/8"
(10 mm)