Assembly Manual

53
Roof panels may cause serious injury until securely fastened.
1
BEGIN
2" (5,1 cm)
PARTS REQUIRED:
ROOF PANELS
x174
3/4" GAUGE
BLOCK
Attach the 15-7/8" x 48" panel with the rough side up (painted-grid lines side)
with a 3/4" (1,9 cm) measurement on the rafter (Fig A).
The panel is ush at the gable end overhang (Fig. B),
and the panel is 1/2" from the end rafter (Fig. C).
Secure panel with two 2" (5,1 cm) nails in the corners.
2
Attach a 15-7/8" x 96" roof panel with the rough side up with a
3/4" (1,9 cm) measurement on the rafter (Fig A) and ush with
the installed panel (Fig. C).
Secure panel with two 2" (5,1 cm) nails in the corners.
Flush
3/4"
(1,9 cm)
Gauge
Block
Fig. A
Fig. C
15-7/8" x 48"
Two Nails
Flush
at rafter ends.
Fig. B
Two Nails
Flush
at rafter ends.
Fig. B
3/4"
(1,9 cm)
Gauge
Block
Fig. A
Flush
Fig. C
15-7/8" x 96"
1/2"
(1,3 cm)
7/16 x 15-7/8 x 23-7/8"
(1,1 x 40,3 x 60,6 cm)
x2
7/16 x 15-7/8 x 96"
(1,1 x 40,3 x 243,8 cm)
x2
7/16 x 15-7/8 x 48"
(1,1 x 40,3 x 121,9 cm)
x2
7/16 x 48 x 96"
(1,1 x 121,9 x 243,8 cm)
x2
7/16 x 48 x 71-7/8"
(1,1 x 121,9 x 182,6 cm)
x2