Assembly Manual

55
PARTS REQUIRED:
ROOF PANELS
NOTE: Measurement from outside of wall panelNOTE: Measurement from outside of wall rafter
24-3/8"
(61,9) cm)
24"
(61 cm)
24"
(61 cm)
24"
(61 cm)
24"
(61 cm)
24"
(61 cm)
1/2"
(1,3 cm)
GAP
Fig. B
Fig. E
Flush
2" Nails
Fig. C
Place a 48" x 96" upper roof
panel with the rough side up and
ush to lower panels.
Ensure 1/2" gap at gable end rafter
(Fig. B) and 3/4" measurement on
the rafter (Fig. A).
Secure the lower edge of roof
panel using two 2" nails in corners
as shown.
Move up to the top of the panel
and keep spacing between the
center of the rafters (Fig. C).
Secure with one 2" nail into each
rafter (Fig. C).
Place a 48" x 71-7/8" upper
roof panel, rough side up and
ush with the installed
48" x 96" panel (Fig. D).
Ensure 1/2" gap at gable end
rafter (Fig. E).
Secure the lower edge of roof
panel using two 2" nails in
corners as shown.
Move up to the top of the panel
and keep spacing between the
center of the rafters (Fig. C).
Secure with one 2" nail into
each rafter (Fig. C).
5
6
Flush
Fig. D
3/4"
(1,9 cm)
Gauge
Block
Fig. A
Two Nails
NAIL
FIRST
Flush
Two Nails
NAIL
FIRST
48 x 96"
48 x 71-7/8"
1/2"
(1,3 cm)
G A P
24-3/8"
(61,9) cm)