Assembly Manual

57
PARTS REQUIRED:
You have  nished your gable trim units.
FINISH
GABLE TRIM
x2
3/8 x 4-3/4 x 64-1/8" (1 x 12,1 x 162,9 cm)
x2
3/8 x 4-3/4 x 64-1/8" (1 x 12,1 x 162,9 cm)
x4
2 x 4 x 64-1/8" (5,1 x 10,2 x 162,9 cm)
ATA
ATA
1-1/2"
(3,8 cm)
Nails
3/8" x 4-3/4" x 64-1/8"
(x2 Left & x2 Right)
Primed Side Down
Flush
Flush
Approximately
12"
(30,5 cm)
Flush
BEGIN
1
Secure with 1-1/2" nails spaced evenly (approximately 12" (30,5 cm).
Orient parts on  oor. Line up 3/8" x 4-3/4" x 64-1/8" trim primed side down on top of ATA. Trim is
 ush with ATA at end and along edges as shown (Fig. A).
x24
1-1/2" (3,8 cm)
You will build two LEFT and two RIGHT gable trim units.
Fig. A
LEFT
RIGHT
Primed side
down