Assembly Manual

58
PARTS REQUIRED:
GABLE TRIM
3" (7,6 cm)
x2
RIGHT gable trim unit
LEFT GABLE TRIM UNIT
Flush
Flush
Flush
Flush
3" (7,6 cm)
Screws
3" (7,6 cm)
Screws
Flush at
Seam
RIGHT GABLE TRIM UNIT
x2
LEFT gable trim unit
24"
(61 cm)
Approximately
x16
Flush
Fig. B
You have  nished installing your gable trim units.
FINISH
BEGIN
1
Secure with 3" screws into end rafter and spaced evenly (approximately 24" (61 cm).
Secure with 3" screws into end rafter and spaced evenly (approximately 24" (61 cm).
Repeat Steps 1 - 2 for opposite side.
Line up RIGHT gable trim unit  ush to gable panel center seam and  ush with roof sheathing
(Fig. A, Fig. B).
Line up LEFT gable trim unit  ush to RIGHT gable trim unit and  ush with roof sheathing
(Fig. A, Fig. B). Check gable trim units are  ush at peak.
3
2
3" (7,6 cm)
Screws
Flush
Fig. A
End View
Flush at Peak