Assembly Manual

76
SHUTTERS & WINDOW TRIM
2
Repeat Step 1 to build 2nd shutter.
PARTS REQUIRED:
1" (2,5 cm)
x20
Locate AZ centered on marks and seam as shown. Attach using 2" nish nails.
Nail into double studs.
Position DHA on top of DJA primed side down as shown. Square and mark.
Attach DHA using 1" screws.
Flush
2-1/2"
(6,3 cm)
2-1/2"
(6,3 cm)
Parts primed side down
Flush
DHA
DJA
AZ
x4
19/32 x 2-1/2 x 30-1/8" (1,5 x 6,3 x 76,5 cm)
AZ
2" (5,1 cm)
Finish Nails
into wall frame
1" (2,5 cm)
Screws
BEGIN
1
x4
19/32 x 2-1/2 x 11" (1,5 x 6,3 x 27,9 cm)
DJA
x4
19/32 x 5-1/2 x 30-1/8" (1,5 x 14 x 76,5 cm)
DHA
x14
2" (5 cm)
3
4
Locate shutter just past the inside of the vertical screw holes on window ange.
Center shutter from top to bottom of window as shown.
Attach shutter using 2" nish nails indicated at "dot". Nail into wall studs.
From inside, attach shutter using 1" screws indicated at "X".
Repeat steps to attach shutter on opposite side.
1" Screws
from inside
CENTER CENTER
CENTER CENTER
CENTERCENTER
Assembled Shutters
x2