Assembly Manual

79
Fig. D
x19
2" (5 cm)
PARTS REQUIRED:
DOOR TRIM
ZJ
DDA
Flush ZJ with bottom of wall panel and single
door (Fig. D).
Ensure 3/8" gap between door and trim (Fig. D).
Secure using 2"  nish nails into framing
as shown.
2
ZJ
x1
19/32 x 2-1/2 x 72" (3,2 x 6,3 x 182,9 cm)
x1
DDA
19/32 x 3-1/2 x 40" (1,5 x 8,9 x 101,6 cm)
3/8"
(1,0 cm)
CENTER
FlushFlush
Flush
CENTER
CENTER CENTER
x1
19/32 x 6-7/16 x 5-1/2" (1,5 x 17,5 x 14 cm)
NRA
x1
19/32 x 6-7/16 x 2" (1,5 x 16,4 x 5,1 cm)
JTA
NRA
JTA
BEGIN
1
Center trim DDA over door  ush to
hinge board and ZJ.
Secure using 2"  nish nails into framing
as shown (Fig. D).
2" (5,1 cm)
Finish Nails
into wall frame
2" (5,1 cm)
Finish Nails
into wall frame
FINISH
3
4
Locate JTA centered over door trim.
Attach using one 2"  nish nail close to trim as shown
(Fig. E).
Place NRA centered over JTA.
Attach using  ve 2"  nish nails as shown (Fig. F).
Nail into JTA and framing at bottom.
You have  nished installing your single door trim.
Fig. E
Fig. F