Assembly Manual

18
PARTSREQUIRED:
FINISH
3
You have nished building the main roof rafter jig. Proceed to assemble your trusses.
MAIN ROOF TRUSS ASSEMBLY
120"
(304,8 cm)
120"
(304,8 cm)
144"
(365,8 cm)
36"
(91,4 cm)
36"
(91,4 cm)
60"
(152,4 cm)
3/4"
(1,9 cm)
PVAx3
3" (7,6 cm)
x6
x3
PVA
2 x 4 x 5-7/8" (5,1 x 10,2 x 14,9 cm)
Measure over 60" and up 36" from the oor edges and secure the third PVA using two 3" screws.
Check this PVA is 36" at both ends for squareness.
BEGIN
¸
1
Secure one PVA ush to the oor deck using two 3" screws.
Measure over 120-3/4" and install a second PVA ush to the oor deck. PVA will overhang the oor.
Secure using two 3" screws.
2
120-3/4"
(306,7cm)
IMPORTANTMEASUREMENT!!
Fig.B
Fig.A
You will build a rafter jig using the gable end of oor and three PVA parts as shown.
Floor Width
(2)3"(7,6cm)
Screws
in each PVA
There will be an
overhang on
thisend.
Flush
Flush
Foranevenandatroofitisvery important to assemble your trusses
using the following method:
DOOR
DOOR