Assembly Manual

PARTSREQUIRED:

x20

2" (5,1 cm)

1-5/8" (4,1 cm)

DORMER TRUSS ASSEMBLY (LEFT 1 GUSSET)

4-13/16 x 24" (12,2 x 61 cm)

OSBORWOODGRAIN

2 x 4 x 75-1/4" (5,1 x 10,2 x 191,1 cm)

ECN

KGA

ECN

Fig.A

Fig.B

1/4"(1,9cm)

GAP

1/4"(1,9cm)

GAP

Fig.C

Gluewhere

gusset installs

KeepraftersrmlyagainstPVAatbothendswhensecuringgusset.

Remove TEMPORARYOSBPANEL from truss and

PVA's from oor.

HandleTEMPORARYOSBPANELcarefullyasitwill

beusedlaterasaroofpanel.

Flip rafters over and attach the gusset using glue (Fig.B) and (12) 2" nails to nish securing the gusset to

the rafters with pattern shown (Fig.C). No need to use jig for this gusset.

7

Keep KGA and ECN rm against outside PVA's as shown (Fig.A) and push rafters tight to the middle PVA.

Rafters should touch at tips (Fig.A).

Place gusset onto KGA and ECN holding a 1/4" gap from edge (Fig.C) and keeping rafters rm as instructed.

Secure TEMPORARYOSBPANEL using two 1-5/8" screws into each rafter. HINT: the TEMPORARYOSB

PANEL will hold the measurements when you ip over the rafters to install the gusset (FigB). Do not glue.

Place rafters KGA and ECN into the jig as shown.

1-5/8"(4,1cm)

Screws

120-3/8"

(305,8 cm)

KGA

2 x 4 x 61-13/16" (5,1 x 10,2 x 157 cm)

KGA

ECN

You have nished assembling your dormer trusses.

FINISH

7/16 x 7-11/16 x 24"

(1,1 x19,5 x 61 cm)

TEMPORARYOSBPANEL