Assembly Manual

48
GABLE UNITS
PARTSREQUIRED:
RL
3" (7,6 cm)
x8
3"
(7,6cm)
Screws
x2Gable Units
BEGIN
2
Continue nailing lower edge of panels into top plate using 2" nails 6" apart as shown
You have nished attaching your gable units.
FINISH
5
On the inside, secure gable unit with 3" screws toe-screwed into RL at an angle as shown in (Fig.B).
3
2" (5,1 cm)
x42
4
Repeat Steps 1-3 to attach back gable unit.
On the inside, secure gable with two 3" screws toe-screwed into RL at an angle as shown in (Fig.B).
Fig.B
TOPPLATE
Stand gable unit on gable wall top plate. Measure 1-1/2" down from top plate and mark at each side as shown.
Hold secure with one 2" nail on each side as shown.
1
BESUREGABLEUNITISCENTEREDONWALLBEFORENAILING.
RL
RL
3"
(7,6cm)
Screws
NAILFIRST
2"(5,1cm)
NAILFIRST
2"(5,1cm)
6"
(15,2 cm)
Fig.A
TOPPLATE
1-1/2"
(3,8cm)
Measure and
Mark
1-1/2"
(3,8cm)
Measure and
Mark
Itisimportanttosecurethegable unit in the following order: