Assembly Manual

Roofpanelsmaycauseseriousinjuryuntilsecurelyfastened.

BEGIN

2" (5,1 cm)

PARTSREQUIRED:

ROOF PANELS

7/16 x 32-5/8 x 48"

(1,1 x 82,9 x 121,9 cm)

x234

3/4"GAUGE

BLOCK

7/16 x 27-1/4 x 48"

(1,1 x 69,2 x 121,9 cm)

3/4"

(1,9 cm)

Gauge

Block

Fig.A

Fig.C

Flush

atrafterend.

Fig.B

Flush

atrafterend.

Fig.B

Two Nails

Move to the outside edge. Using the long edge of the panel as a lever move the panel side-to-side until

the outside long edge is ush with the outer gable frame (FigB).

Secure with two 2" nails.

You may need to move your truss and gable

frameunittomakepanelushwithouter

gableframe(Fig.C).

You must square the roof by attaching one 32-5/8x48" panel at this time.

You will use the panel's long edge as a lever to bring your roof into square.

Place the 32-5/8x48"roof panel as shown with the rough side up. Use a

gauge block to ensure the panel measures 3/4" (1,9 cm) along the length of

the rafter(Fig.A). Panel should be ush with end of rafter (Fig.B).

Secure with two 2" nails.

Flush

32-5/8"x48"