Assembly Manual

57
PARTSREQUIRED:
ROOF PANELS
NOTE: End-measurement from outside of gable.
7/16 x 48 x 96"
(1,1 x 121,9 x 243,8 cm)
x1
24"
(61 cm)
24"
(61 cm)
11-1/4"
(61 cm)
11-1/4"
(61 cm)
12-3/4"
(61 cm)
12-3/4"
(61 cm)
32-5/8"
(82,9) cm)
3/4"
(1,9 cm)
Fig.A
Flush
Flush
Fig.F
Place 48"x96"upper roof panel with the
rough side up and ush with edges of all
installed panels.
Use a gauge block to ensure the panel
measures 3/4" (1,9 cm) along the length
of the rafter(Fig.A).
Secure the lower edge of roof panel using
two 2" nails in corners as shown.
Move up to the top of the 48"x96"
panel and keep spacing between
the center of the trusses (Fig.F).
Use a gauge block to ensure the
panel measures 3/4" (1,9 cm) along
the length of the rafter(Fig.A).
Secure with (7) 2" nails, one into each
rafter (Fig.F).
7
8
Two Nails
NAIL
FIRST
2"Nailat
each truss
48x96"
(121,9x242,8cm)
48x96"
(121,9x242,8cm)
2"Nails
Gauge
Block
Gauge
Block
Flush
32-5/8"
(82,9) cm)
48x96"
(121,9x242,8cm)