Assembly Manual

KKA
x1
2 x 6 x 81" (5,1 x 15,2 x 205,7 cm)
65
HINT: Use KNA as a support.
PARTSREQUIRED:
DORMER ROOF UNIT
7/16 x 35-7/8 x 67-5/8"
(1,1 x 91,1 x 171,8 cm)
x2
1-5/8" (4,1 cm)
x14
KNA
x2
2 x 4 x 52-1/2" (5,1 x 10,2 x 133,3 cm)
TEMPORARYSUPPORT
1
BEGIN
Place KKA on oor or other at surface. Measure and mark KKA at center point (Fig.A).
You have nished assembling your dormer roof unit.
FINISH
5
2
3
4
Place 35-7/8"x67-7/8"roof panel on top of KKA with the rough side up. Ensure panel is on center mark and
ush along front edge. Attach 35-7/8"x67-7/8"roof panel using (6) 1-5/8" screws in a staggered pattern.
Place second 35-7/8"x67-7/8"roof panel on top of KKA as shown with the rough side up. Ensure panel is ush
at seam and along front edge. Attach 35-7/8"x67-7/8"roof panel using (6) 1-5/8" screws in a staggered pattern.
Attach GAA as a temporary panel stabilizer using 1-5/8" screws as shown.
Fig.A
KKA
Flush
Flush Flush
1-5/8"(4,1cm)Screws
-Staggered Pattern-
1-5/8"(4,1cm)Screws
40-1/2"
(102,9 cm)
40-1/2"
(102,9 cm)
KNA
TEMPORARYSUPPORT
GAA
TEMPORARYSTABILIZER