Assembly Manual

82
DOOR HARDWARE
PARTSREQUIRED:
x4
Re-drill hole with 1/2" drill (Fig.B).
Keep drilled hole square to trim to avoid breaking edge of 1-1/2" x 2-1/2" door stiffener.
BEGIN
1
2
Measure and mark location of hole on outside of right door as shown (Fig.A).
Pre-drill hole with 1/4" drill.
1/2" (13 mm) Drill Bit
1/4" (6 mm) Drill Bit
3/4" (1,9 cm)
x12
You have nished preparing your door for door handle.
FINISH
6
Install decorative hinges on horizontal trim and ush against hinge as shown.
5
TOPVIEW
1"
(2,5 cm)
1/4"Pre-drilland
1/2"Drill-through
Fig.A
1-3/4" (4,4 cm)
35-3/4"
(90 cm)
RIGHTDOOR.
1/2"
1,3 cm
SIDEVIEW
Fig.B
Screws
3/4"(1,9cm)x12
1"
(2,5 cm)
Attach inside handle and secure
with set screw as shown.
4
Insert handle in hole and secure using 1-1/2" (3,8 cm) screws.
3
1-1/2"(3,8cm)
Screws
SET
SCREW
x1