Assembly Manual

85
Flush at
SEAM
PARTSREQUIRED:
LOFT
x1
2 x 4 x 96" (5,1 x 10,2 x 243,8 cm)
TP
x14
3" (7,6 cm)
2 x 4 x 24" (5,1 x 10,2 x 61 cm)
RL
x1
2 x 4 x 119-7/8" (5,1 x 10,2 x 304,5 cm)
x1
Pre-AssembledLoftJoist
Locate TP and RL ush to bottom of top plate and aligned at seam. Secure with 3" (7,6 cm) nails at wall
studs and seam.
5
7/16" (11 mm) Drill Bit
x2
x4
x2
3/8" x5-1/2" (1 cm x 14 cm)
3/8" (1 cm)
3/8" (1 cm)
HexBolt
FlatWasher
LockNut
(NOTACTUALSIZE)
6
7
Clamp or hold Pre-AssembledLoftJoist in place ush against window crippler and back wall stud.
Ensure Pre-AssembledLoftJoistis ush beneath top plates.
Drill through wall stud with 7/16" drill bit using hole in Pre-AssembledLoftJoist as a guide.
Line up holes of Pre-AssembledLoftJoist with holes in crippler and stud.
Secure joist with hex bolts, at washers and lock nuts at both sides (Fig.B).
Tighten lock nuts securely.
GABLE
WALL
3"(7,6cm)
Nails
TP RL
Flush
Flush
Fig.B
Flush
Flush
JOISTTOFRONTOF
WINDOWCRIPPLER
JOISTTOFRONTOFSTUD