Save This Manual for Future Reference YARDMAN &= Single-Stage Snow Thrower Operator's Manual MODEL NUMBER YB4628 SERIAL NUMBER L ] PURCHASE DATE Both mandrel number and serial number may be found on the wain label, You should record both of them in a safe place for future use.
Your new YARDMAX® snow thrower offers quality construction, and is easy and safe to operate. With proper use and care, it is designed to give you many bears of dependable service. Prepare to experience the durability to take on any job with the ease, portability, and convenience of your new snow thrower! Discover the YARDMAN Advantage At YARDMAN, we understand that land ownership definitely has its privileges, but it also comes with a great deal of responsibility.
Cara fully read through this entire aerator's manual A before using your new unit, Pay attention to all cautions and warnings. This unit is a gasoline engine driven snow thrower, 1t is perfect for tackling light to medium snow fall easily able to remove snow up to 117 deep. it s easy and safe to operate. With proper use and care, it should give you many years of dependable service.
SAFETY GENERAL SAFETY RULES UNDERSTAND YOUR MACHINE Read this manual and labels affixed to the machine to understand its limitations and potential hazards, Be thoroughly familiar with the controls and their proper operation. Know how to stop the making and disengage the controls quickly.
ENGINE SATIETY This machine is equipped with an internal combustion engine, Do not use on or near any unimproved, forest covered, or brush covered land unless the exhaust system is equipped with a spark arrested meeting applicable local, state, or federal laws, In the state of California, a spark arrested is required by faw. Other states have similar laws. A spark arrested, f used, roust be maintained in effective working ponder by the operator. Ever start or run the engine inside a closed area.
SPECIFIC SAFETY RULES Do not operate without wearing adequate winter outer garments. Do not use the machine on a roof. Do not run the engine indoors, except when starting the engine and for transporting the snow thrower in or out of the bulling. Pen the outside doors; exhaust fumes are dangerous. Always check overhead and side clearances carefully before operation. Always be aware of traffic when operating along streets or curbs. Thoroughly inspect the area to be worked.
Single-Stage Snow Blower » Operator's Manual CONTENTS SUPPLIED ‘Your YARDMAN snow thrower comes partially assembled and contains the following: 1. Main Machine 8. Engine Oil 2. Handlebars 9. Hardware Kit, Including 3. Discharge Chute 4. Directional Chute Control Handle o Tested X n 5. Wheels Quo X2 E 6. Operator’s Manual & Engine Manual O: @ © MBX45 X4 fl 7.
HANDLEBAR RECOIL STARTER 4. Align the holes in the handcars and the holes in the lower 1. Rapunzel the nut and arc washer from the eye bolt. handle. Mote Guffaw 38 b Below that The handier must face upward to work property. 2. Insert the eye it info the mounting hole found on the right side of the lower handle. Secure it with the arc washer and nut that were removed Instep 1. 1.
KNOW YOUR MACHINE g i ity el s FEATURES AND CONTROLS Cli Drain Plug el 11 | Know Your Machine YB4GLAPMOT 1612
Engage choke by rotating lever to CLOSER position » whenever you ang starting 3 cold engine, As engine warms:up, gradually rotate the choke to the GEN position. l & Never use choke to sip engine. N PRIMER Press the primer to pump additional fuel from the M carburetor to the cylinder for improved cold weather starting, Firmly push in the primer with your thumb, holding » the primer in for a second before releasing it sate time.
ALGEBRAICALLY The auger will not turn unless the rigger clutch is engaged. The:auger must stop within 5 seconds after the auger clutch Is released. The clutch cable must contain some slack when you disengage the clutch lever for the auger to stop prophecy. if the lager i longer turns when the auger dutch is engaged or if the belt slips under load, the auger cable or bt may have stretched. This Can be compensated for by adjusting the auger crutch cable.
OPERATION STARTING AND STOPPING THE ENGINE ensure the engine is maintained as described in the Engine Manuel with the snow thrower. ? Before starting the engine, check engine off level and COLD START RECOIL STARTER 1. Be sure fuse shutoff valve is in the FEN position. . Place ON/ OFF switch in ON position. . Rotate choke control to CLOSED position. Push the primer 2 or 3 times. Wuhan temperature is below 15°F additional priming may be needed. When temperature is above S0°F priming Is not necessary.