Instructions / Assembly

Recoil Starter Handle
The gas spring assistance provides support when
lifting and lowering the hopper.
GAS SPRING ASSISTANCE
GEAR SELECTION LEVER
The gear selection lever has 4 positions: 3 forward
speeds and 1 reverse. To change speeds, move the
speed shift lever to the desired position. The lever
locks in a notch at each speed selection.
Slower speeds are for heavier loads, while faster
speeds are for transporting light loads or an empty
hopper. It is recommended that you use a slower
speed until you are familiar with the operation of the
power trackbarrow.
If the engine slows down under a load or the tracks
slip, shift the machine into a lower gear.
If the front of the machine rides up, shift the machine
into a lower gear. If the front continues to ride up, lift
up on the handles.
Always release the clutch control lever before changing
speeds. Failure to do so will result in damage to the
power trackbarrow.
Operate the lever to turn left/right.
LEFT/RIGHT STEERING LEVER
Operate the steering levers only at a reduced speed.
Never use choke to stop engine.
ENGINE ON/OFF SWITCH
The engine switch has two positions. OFF - engine will
not start or run. ON - engine will start and run.
RECOIL STARTER HANDLE
The recoil starter handle is used to start the engine.
FUEL SHUT-OFF VALVE
The fuel shut-off has two positions:
CLOSED
(
) - Use this position to service, transport,
or to store the unit.
OPEN
(
) - Use this position to run the unit.
THROTTLE CONTROL
The throttle control regulates the speed of the engine,
and moves between FAST
, SLOW , and STOP
positions.
The throttle control will shut off the engine when it is
moved to the STOP position.
CHOKE CONTROL
The choke control is used to choke the carburetor and
assist in starting the engine. The choke control slides
between the
CHOKE CLOSED
and
CHOKE OPEN
positions.
CLUTCH CONTROL LEVER
Squeeze the control lever, clutch engaged. Release
the lever, clutch disengaged.
Choke Control
Fuel Shut-Off Valve
Throttle Control
12
Power Trackbarrow
»
Operator’s Manual
YD8103PM03 - 1802
Know Your Machine
|