Instructions / Assembly

Rapid retraction of the starter cord (kickback) will pull
your handand arm toward the engine faster than you
can let go. Broken bones, fractures, bruises, or sprains
could result.
4. Move the throttle lever slightly
to the FAST speed.
5. Pull the recoil starter until the engine starts. Return the recoil
to the home position after each pull. Repeat the steps as
needed. Once engine has started, set the throttle to the FAST
position before you operate the unit.
SLOWFAST
OPENCLOSED
OPERATING
After the engine warms up, move the throttle lever to accelerate
engine speed.
Engage the required gear and slowly squeeze the clutch control
lever. If the gear does not engage immediately, slowly release the
clutch lever and try again. In this way the power trackbarrow will
start moving.
The power trackbarrow has the steering levers on the handlebars,
which makes steering very easy. To turn right or left, simply pull
the corresponding right or left steering lever.
The sensitivity of the steering increases in proportion to the
speed of the machine and the load. With an empty machine, a
light pressure on the lever is all that is needed to turn. When the
machine is fully loaded, more pressure is required.
The power trackbarrow has a maximum capacity of 660 LBS.
However, it is advisable to assess the load and adjust it according
to the ground on which the machine will be used.
It is therefore advisable to cover such stretches using low gear and
taking extra care. In such situations, the machine should be kept in
low gear for the whole stretch.
Avoid sharp turns and frequent changes of direction while driving
on rough, hard terrains full of sharp, uneven points with a high
degree of friction.
Even though the unit has rubber tracks, remember to be careful
when working in adverse weather conditions (ice, heavy rain
and snow) or on types of ground that could make the power
trackbarrow unstable.
Please note that as this is a tracked vehicle, it is subject to a
considerable pitching movement when passing over bumps, holes
and steps.
When the clutch control lever is released, the machine will stop
and brake automatically.
If the machine is stopped on a steep slope, a wedge should be
placed against one of the tracks.
IDLE SPEED
Set the throttle control lever to the SLOW position to reduce
stress on the engine when work is not being performed. Lowering
the engine speed will help extend the life of the engine, as well as
conserve fuel and reduce noise level.
STOP ENGINE
To stop the engine in an emergency, simply turn the engine switch
to the OFF position. Under normal conditions, use the following
procedure:
1. Move the throttle lever to the SLOW (
) position.
2. Let the engine idle for one or two minutes.
3. Turn the engine switch to the OFF position.
4. Turn the fuel valve lever to the OFF (
) position.
Do not move the choke control to CLOSE to stop the
engine. Backre or engine damage may occur.
Sudden stopping at a high speed under a heavy load
is not recommended. Engine damage may result.
14
Power Trackbarrow
»
Operator’s Manual
YD8103PM03 - 1802
Operation
|