Instructions / Assembly
Never use a “pressure washer” to clean your unit.
Water can penetrate tight areas of the machine and
its transmission case and cause damage to spindles,
gears, bearings, or the engine. The use of pressure
washers will result in shortened life and reduce
serviceability.
GEARBOX
The gearbox was lled with lubricant to the proper level at the
factory. Unless there is evidence of leakage or service has been
performed on the gearbox, no additional lubricant should be
required. If lubricant is required, use GL-5 or GL-6, SAE85-95, EP
gear oil lubricant. Do not use synthetic oil.
GENERAL LUBRICATION
Lightly lubricate all moving parts of the machine at the end of the
season or every 25 operating hours.
ADJUSTING CLUTCH
When the clutch begins to show wear, the handle
reach will become wider, making it more difcult to
reach. Follow these steps to return the clutch lever
back to its original position.
1. Loosen the jam nut by turning it counter clockwise
with 10mm wrench. (see Figure 4, Illustration 1)
2. Tighten or loosen the cable by turning the cable
adjustment nut clockwise or counter clockwise with
10mm wrench until you have reached your required
tightness. (See Figure 4, Illustration 2)
3. Once tightness is set, return the jam nut against
the handle to hold the cable in place. (See Figure 4,
Illustration 3)
MAINTENANCE
Maintaining your YARDMAX power trackbarrow will ensure long
life to the machine and its components.
PREVENTIVE MAINTENANCE
1. Turn off the engine and disengage all command levers. The
engine must be cool.
2. Keep the engine’s throttle lever in its SLOW position and
remove the spark plug wire from the spark plug and secure.
3. Inspect the general condition of the power trackbarrow. Check
for loose screws, misalignment or binding of moving parts,
cracked or broken parts, and any other condition that may
affect its safe operation.
4. Use a soft brush, vacuum or compressed air to remove all
contaminants from the machine. Then use high quality light oil
to lubricate all moving parts.
5. Replace the spark plug wire.
ADJUSTING STEERING
If steering becomes difcult to engage follow these
steps to adjust the cable tension.
1. Loosen the jam nut by turning it counter clockwise
with 10mm wrench. (see Figure 5a, Illustration 1)
2. Tighten or loosen the cable by turning the cable
adjustment nut clockwise or counter clockwise with
10mm wrench until you have reached your required
tightness. (see Figure 5a, Illustration 2)
3. Once tightness is set, return the jam nut against the handle
to hold the cable in place. (see Figure 5a, Illustration 3)
Jam Nut
Adjustment Nut
Adjustment Nut
Jam Nut
Jam Nut
1
2 3
Figure 4
10
mm
13
mm
17
mm
19
mm
12
mm
7
mm
30
mm
8
mm
15
YD8103PM03 - 1802
|
Maintenance