Save This Manual for Future Reference Electric Log Splitter Operator’s Manual MODEL NUMBER YS0952 SERIAL NUMBER PURCHASE DATE Both model number and serial number may be found on the main label. You should record both of them in a safe place for future use.
Your new YARDMAX® electric log splitter offers quality construction, and is easy and safe to operate. With proper use and care, it is designed to give you many years of dependable service.
Electric Log Splitter » Operator’s Manual DISCLAIMER Carefully read through this entire operator’s manual before using your new Log Splitter. Pay attention to all cautions and warnings. CALIFORNIA PROPOSITION 65 WARNING Engine exhaust, some of its constituents and certain product components contain or emit chemicals known to the state of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
SPECIFICATIONS Model Number YS0952 Splitting Force 9 ton (+/- 10%)* Log Capacity 20.5" L x 12.6" dia. Wedge Size 6" Hydraulic Capacity 1.72 gal Forward: 7s – 16s Cylinder Cycle Time Reverse: 7s Wheel size 8" Motor 15 amp Product Weight 165 lb Cylinder Size 2.75" Product Dimensions 41.7" x 10.9" x 20.
Electric Log Splitter » Operator’s Manual SAFETY KNOW YOUR LOG SPLITTER Read this manual and all labels to understand your YARDMAX log splitter and its limitations and potential hazards. DRUGS, ALCOHOL, AND MEDICATION Do not operate your log splitter while under the influence of drugs, alcohol, or any medication that could affect your ability to use it properly. AVOID DANGEROUS CONDITIONS Secure your log splitter on level ground. Keep your work area clean and well lighted.
CONTENTS SUPPLIED Your YARDMAX log splitter comes completely assembled and contains the following: 1 9 1. Log Splitter 2.
Electric Log Splitter » Operator’s Manual KNOW YOUR MACHINE FEATURES AND CONTROLS Log Pusher Work Table Control Lever Guard Wedge Log Retaining Plates Lift Handle Wheels for Minor Moving ONLY Switch Box Support Leg Switch Motor Hydraulic Control Lever Bleed Screw Oil Drain Bolt w/ Dipstick BLEED SCREW Before operating your log splitter, loosen the bleed screw enough to allow air to freely flow in and out of the oil tank.
MAX PRESSURE LIMITING SCREW Max pressure was preset at the factory by a qualified mechanic using professional tools. Max Pressure Limiting Screw Unauthorized resetting will prevent the hydraulic pump from providing enough splitting pressure or RESULT IN SERIOUS INJURY AS WELL AS DAMAGE TO THE MACHINE.
Electric Log Splitter 2-STAGE CONTROL » Operator’s Manual Do not put any logs on the log splitter at this stage. POSITION 1 POSITION 2 2. Loosen the handwheel on the return stop. 3. Slide the stop to the desired position, moving the stop toward the splitter to shorten the stroke. ADVANCE to LOG SPLIT LOG The splitting force and speed are governed by the 2-stage control lever. Push the lever to POSITION 1 to advance (faster) to the log using less splitting force. Don’t split the logs at POSITION 1.
FREEING A JAMMED LOG Release both controls. A fter the log ram moves back to its starting position and completely stops, insert a wood wedge under the jammed log. Never try to knock a jammed log off the splitter with your hand or another object. This could damage the tool or cause the log to fly up and hit someone. S tart the log splitter to push the wood wedge completely under the jammed log. R epeat above procedure with sharper-sloped wood wedge until the log is completely freed.
Electric Log Splitter » Operator’s Manual REPLACING HYDRAULIC OIL Disassemble the log tray table before replacing the hydraulic oil. Tip the log splitter so the oil drain plug is higher than the motor and refill with 1.72 gallon (7 qt) of fresh hydraulic oil. Replace the hydraulic oil in your YARDMAX log splitter after every 150 hours of use. Follow these steps to replace it: Make sure all moving parts stop and the log splitter is unplugged. U nscrew the oil drain bolt with dipstick to remove it.
C lean the oil drain bolt with dipstick before screwing it back in. Tighten it to avoid leakage before setting the log splitter down. Periodically check oil level to ensure it is between the two grooves on the dipstick. Refill with oil if it becomes low. The following hydraulic oils or equivalents are recommended for your log splitter's hydraulic transmission system: 1 0W AW32 A SLE H-150 I SO 32 SHARPENING THE WEDGE Over time your YARDMAX log splitter wedge will dull.
Electric Log Splitter » Operator’s Manual TROUBLESHOOTING Problem Cause 1. Log is improperly positioned 2. T he sizes or hardness of the log exceeds the capacity of the machine Fails to split logs 3. W edge cutting edge is dull 4. Oil leaks Log ram moves inconsistently, making unfamiliar noises or vibrations 2. Reduce the log sizes before splitting 3. Refer to Sharpening the Wedge section to sharpen the cutting edge 4.
PARTS DIAGRAM 13 | Parts Diagram YS0952PM00 - 2002
Electric Log Splitter » Operator’s Manual PARTS LIST No. Description QTY. No. Description QTY. 1 Nut 4 31 Hex. Bolt M8x20 2 2 Snap Washer 22 1 32 Moving Handle 1 3 Washer 10x2 1 33 Washer 16 2 4 Valve Rod 1 34 Nut M16 2 5 O-Ring 8.75x1.8 1 35 Copper Washer 12 4 6 Safety Valve Spring basis 1 36 Safety Valve 1 7 O-Ring 11.2x2.65 3 37 O-Ring 17x1.8 5 8 Safety Valve Spring 1 38 Screw M10x8 2 9 Safety Valve 1 39 Steel Ball 8.
No. 15 | Description QTY. No. Description QTY. 61 Wheel Cover A 2 91 Pin 8x24 2 62 Wheel Shaft Snap Ring A 16 2 92 Gear Housing Plate 1 63 Wheel A 2 93 Motor Support Shoe - Right 1 64 Wheel Shaft Frame 1 94 Motor Cover 1 65 Nut M8 5 95 Motor Support Shoe - Left 1 66 Nut M10 4 96 Seal FB11x26x7 1 67 Hex. Bolt M8x35 1 97 Motor Assembly 1 68 Log Pusher 1 69 Washer 6 4 70 Cross Headed Screw M6x12 4 71 Body Cover - Left 1 72 Hex.
Electric Log Splitter YS0952PM00 - 2002 » Operator’s Manual | 16
17 YS0952PM00 - 2002
Electric Log Splitter YS0952PM00 - 2002 » Operator’s Manual 18
yardmax.com Tame the Great Outdoors 847-327-0566 or 844-YARDMAX | ® info@yardmax.
