Installation Instructions

ManualsBrandsYardworks ManualsBuilding materials4-10 x 7-9 Black Steel Fence Panel

Important: Read all directions in advance of project install

Importante: Lea todas las instrucciones antes de instalar el proyecto.

Steel Fence Install

HARDWARE / ADITAMENTOS

Quantity / Cantidad

Panel / Panel

Description / Descripción

Brackets / Abrazaderas

Self Tapping Screw / Tornillo autorroscante

Hinge Bolt (Gate) / Perno para bisagra (puerta)

Hinge Bolt (Post) / Perno para bisagra (poste)

Acorn Nut / Tuerca ciega

Gate

Hinge / Bisagra

Latch - NOT Pool Code Compliant / Pestillo – NO cumple con el código para piscinas

G I

Required Tools Hammer, tape measure, mason’s string, wood stakes, shovel, post hole digger, wheel

barrow, electric drill, Phillips drive bit, wood blocks, level, hack saw, jig saw or hand held band saw.

Herramientas necesarias:

martillo, cinta métrica, cuerda para mampostería, estacas de madera, pala, barrenadora para postes, carretilla, taladro eléctrico, punta de destornillador

Phillips, topes de madera, nivel, sierra de mano, sierra de vaivén o sierra de banda de mano.

Instalación de cerca de acero

Packaged Together / Empaquetados juntos

Summary of content (4 pages)

PAGE 1
Steel Fence Install Instalación de cerca de acero Important: Read all directions in advance of project install Importante: Lea todas las instrucciones antes de instalar el proyecto.
PAGE 2
Fig. 1 1. Plan Your Design Decide on your fence layout, remember posts will be placed at 8 foot intervals. For ease of installation, try to plan layout in increments of 8 feet. This will keep cutting panels to a minimum. We will discuss cutting panels in Step 7. Stake out the perimeter of your fence with stakes. Then stretch mason’s string as a reference line to keep posts in line while installing. (Fig. 1) Mark the spots where you will be digging holes for posts.
PAGE 3
5. Panel Install Start by sliding brackets into each end of fence rail. Screw tab must be facing down. (Fig. 6) Position the panel in between posts, and use blocks to prop bottom of panel 2 in. above ground. Check panel for level. (Fig. 7) You may need to shim panel till level. Drill a 1/16 in. pilot hole through the bracket into the post. Insert the self tapping screw through the top hole in the mounting bracket and use the Phillips driver bit to drive the screw into the post.
PAGE 4
8. Install Gate Start by planning the swing of the gate. Hinges go on the side of the fence in the direction the gate will open. Set the hinges on the frame of the gate and line up with pre-drilled holes. Attach hinges to gate with nut and bolts (included). (Fig 12.) Next block up the bottom of the gate to the desired height, making sure it is level. Mark post and drill pilot holes in post. Then drill 3/8 in. through holes in post. Use nuts and bolts to attach hinges to post. Remove blocks.