User Manual

model number 054-5763-6 | contact us: 1.866.523.5218

Filling oil tank:

8"3/*/(6OQMVHDIBJOTBXGSPNQPXFSTPVSDFCFGPSFªMMJOHUIFPJMUBOL

1. Set chainsaw on any suitable surface with Oil Filler Cap (5) facing upward.

2. Clean area around the Oil Filler Cap with cloth and unscrew the cap by turning it counter-

clockwise.

3. Add bar and chain oil until tank is full.

 "WPJEEJSUPSEFCSJTFOUFSJOHPJMUBOLSFªU0JM'JMMFS$BQBOEUJHIUFOCZUVSOJOHDMPDLXJTF

until hand tight.

Important: To allow venting of the oil tank, small breather channels are provided

between the Oil Filler Cap and the strainer. To prevent leakage, ensure machine is left in

a horizontal position (Oil Filler Cap (5) uppermost) when not in use.

It is important to use only the recommended standard bar and chain oil (Grade: ISO

VG32) to avoid damage to the chainsaw. This can be found at the location where you

purchased this saw or your local hardware store. Never use recycled/old oil. Use of non-

approved oil will void the warranty.

Oiling chain

Always check oil level before using saw. Do not attempt to operate the oil system while saw is

in operation. To oil chain, press the Bulb (23). Oil will feed through the Oil Outlet (17) onto the

Guide Bar (9) and chain. Press the Bulb (23) on Oil Filler Cap at least once before each cut.

(See Fig. F)

OPERATION

1. SWITCHING ON AND OFF (See Fig. G)

ATTENTION: Check the voltage and current supply: The voltage and current supply

must comply with the ratings on the product plate.

Assembly