User Manual

model number 054-5763-6 | contact us: 1.866.523.5218

For switching on the tool, press the Lock-off Button (3), then fully press the On/Off Switch (2)

and hold in this position. The Lock-off Button can now be released.

For switching off, release the On/Off Switch.

2. CUTTING

*NQPSUBOU*TUIFPJMUBOLªMMFE $IFDLUIF0JM-FWFM8JOEPXQSJPSUPTUBSUJOHBOE

SFHVMBSMZEVSJOHPQFSBUJPO4FF'JH)3FªMMPJMXIFOPJMMFWFMJTMPX"GVMMPJMUBOLXJMM

last approximately 12 minutes of cutting depending on sawing intensity and stops.

Check recently replaced chain tension about every 10 minutes during operation.

(1)

Connect saw to extension cord. Connect extension cord to power supply. (See Fig. H2)

(2) Make sure section of log to be cut is not laying on the ground. This will keep the chain (10)

from touching the ground as it cuts through the log.

Touching the ground while the chain is moving is dangerous and will dull the chain.

(3) Use both hands to grip saw. Always use left hand to grip Front Handle (6) and right hand to

HSJQ3FBS)BOEMF6TFBªSNHSJQ5IVNCTBOEªOHFSTNVTUXSBQBSPVOETBXIBOEMFT

(See Fig. H3)

 .BLFTVSFZPVSGPPUJOHJTªSN,FFQGFFUTIPVMEFSXJEUIBQBSU%JTUSJCVUFZPVSXFJHIU

evenly on both feet.

(5) When ready to make a cut, push the Lock-off Button (3) completely in with the right thumb

and squeeze the trigger. This will turn saw on. Releasing the trigger will turn the saw off.

Make sure the saw is running at full speed before starting a cut.

(6) When starting a cut, slowly place moving chain against the wood. The wood should be as

DMPTFUPUIFTBXCPEZBTQPTTJCMF)PMETBXªSNMZJOQMBDFUPBWPJEQPTTJCMFCPVODJOHPS

skating (sideways movement) of saw.

(7) Guide the saw using light pressure and do not put excessive force on the saw, or the motor

XJMMPWFSMPBEBOEDBOCVSOPVU*UXJMMEPUIFKPCCFUUFSBOETBGFSBUUIFSBUFGPSXIJDIJUXBT

intended.

(8) Remove the saw from a cut with the saw running at full speed. Stop the saw by releasing

the On/Off Switch (2). Make sure the chain has stopped before setting the saw down.

(9) Keep practicing on scrap logs in a secure working area until you are comfortable, using a

«VJENPUJPOBOEBTUFBEZDVUUJOHSBUF

Assembly