User Manual

model number 054-5763-6 | contact us: 1.866.523.5218

CONDITIONS WHICH REQUIRE CHAIN (10) AND GUIDE BAR (9) MAINTENANCE:

• Saw cuts to one side or at an angle.

• Saw has to be forced through the cut.

• Inadequate supply of oil to the bar and chain.

Check the condition of the guide bar each time the chain is sharpened. A worn guide bar will

EBNBHFUIFDIBJOBOENBLFDVUUJOHEJGªDVMU

After each use, with unit disconnected from power source, clean all sawdust from the guide bar

and sprocket hole.

8IFOSBJMUPQJTVOFWFOVTFB«BUªMFUPSFTUPSFTRVBSFFEHFTBOETJEFT

Replace the guide bar when the groove is worn, the guide bar is bent or cracked, or when

excess heating or burring of the rails occurs. If replacement is necessary, use only the guide

CBSTQFDJªFEGPSZPVSTBXJOUIFSFQBJSQBSUTMJTUPSPOUIFEFDBMMPDBUFEPOUIFDIBJOTBX

REPLACING BAR AND CHAIN

Replace chain when cutters are too worn to sharpen or when chain stops. Only use

replacement chain noted in this manual.

Inspect guide bar before sharpening chain. A worn or damaged guide bar is unsafe. A worn or

damaged guide bar will damage chain and make cutting harder.

Fit the Bar Tensioning Plate (22) tab into the new bar by tightening the screw clockwise. The

UBCQSPUSVTJPOBNVTUCFªUUFEJOUPUIFCBSIPMF4FF'JH/

Assembly